Configuration
The Small Arduino Nano Breakout Board can be configured for many different input and output options. Here is a quick guide for selecting the headers for each option.
D3-D6 as Digital Input
Connect the "Direct Output" jumper only. This will connect the center pin of the terminal block header to the arduino pin.
D7-D10 as Digital Input
No jumpers required
D3-D6 as Digital Output (No Relay)
Connect the "Direct Output" and "Set pin as output" jumpers. This will connect the center pin of the terminal block header to the arduino pin and bypass the input protection.
D7-D10 as Digital Output
Connect the "Set pin as output" jumper. This will bypass the input protection.
D3-D6 as Relay Output
Connect the "Relay Output" and "Set pin as output" jumpers. When the corresponding output is HIGH, the PWR and SIG contacts are connected.
Power Selection
For any of the above configurations, a power supply to the PWR pin may be selected. Pick one of 12V or 5V.
Ground NC Connection
For use with a relay configuration, the NC relay contact may be connected to GND. This will connect SIG to GND when the relay is off.
